431
Bearbeitungen
Änderungen
→Tips and Tricks
==Tips and Tricks==
==Tips and Tricks==
Instructables Class: [[http://www.instructables.com/class/Laser-Cutting-Class/]]
* When cutting very thin structures, cutting both "sides" at once is not suitable, because of the high thermal input. Just make each side of the wall one different layer and cut them one after each other (in best case start two prints - but don´t move the part ;-)
* When cutting very thin structures, cutting both "sides" at once is not suitable, because of the high thermal input. Just make each side of the wall one different layer and cut them one after each other (in best case start two prints - but don´t move the part ;-)