Änderungen

Arduino voltammeter (Quelltext anzeigen)

117 Bytes entfernt , 19:33, 15. Jul. 2014

Zeile 22: Zeile 22:

The values of the given resistors are in the breadboard

picture

−

(from left to right) 100K, 10K, 0.47 Ohm, 220 Ohm, 100K, 2.2K (twice).

+

(from left to right) 100K, 10K(10K/6.8K), 47(0.47/4.7) Ohm, 220 Ohm, 100K, 2.2K (twice).

Henceforth, I refer to them as R1, R2, R3, R4, R5, R6 und R7 respectively,

−

~~With those given~~ values ~~a maximum voltage~~ of ~~55 Volt~~ and

+

The values of R2 and R3 depend from the range you are taking measurement. To decide their proper

−

~~a maximum current of 10.6 Ampere can be measured~~. ~~For different voltages~~

+

value use the table below. Note that you must adapt also the Arduinocode accordingly;

−

~~choose a different~~ R2~~, für different currents a different~~ R3.

+

R2 refers to variable '''V10K_RESISTOR ''' and R3 is '''I0_47_RESISTOR'''

+

Following table lists different values of R2 and its corresponding maximum voltage;

Zeile 46: Zeile 47:

|}

−

~~In case you choose a different value you have to adapt that in the Arduino source, respectively,~~

−

~~Regarding R2, modify the initialization of variable V10K_RESISTOR,~~

−

~~for R3 the variable I0_47_RESISTOR.~~

The value of the resistors R6 und R7 (here given as 2.2K) need not to be exactly like that,

33

Bearbeitungen